Searchable abstracts of presentations at key conferences in endocrinology
Endocrine Abstracts (2010) 22 P833

ECE2010 Poster Presentations Thyroid (122 abstracts)

Is there a need to constitute laboratory- and/or region-specific reference ranges for the screening of thyroid disorders?

Dora Horvath 1 , Erzsebet Toldy 2, , Zoltan Locsei 1 , Rita Nagy 1 , Gabor L Kovacs 3, & Istvan Szabolcs 4


1First Department of Internal Medicine, Markusovszky Teaching Hospital of County Vas, Szombathely, Hungary; 2Central Laboratory of Markusovszky Teaching Hospital of County Vas, Szombathely, Hungary; 3Institute of Diagnostics and Management, University of Pecs, Pecs, Hungary; 4Faculty of Health Sciences Semmelweis University, Budapest, Hungary; 5Laboratory Medicine University of Pecs, Pecs, Hungary.

Usually, the first laboratory marker for thyroid disorders is TSH. FT4 and FT3 must not be measured unless TSH is out of the reference range. However, the reference range for TSH (and for free thyroid hormones) given by the manufacturers of immunoassays may be not completely valid for screening in iodine-deficient areas and among hospitalized patients either.

Aim: Our aim was to constitute specific TSH, FT4, FT3 reference ranges for the population of our moderately iodine deficient western-Hungarian area, to use them for ambulatory and hospitalized patients by comparing to the manufacturer’s reference ranges (TSH: 0.4–4.0 mU/l, FT4: 9–19, FT3: 2.7–5.9 pmol/l) to analyze the difference of the number of free hormone estimations needed and also the difference in the expenses.

Methods: To calculate TSH, FT4, and FT3 reference ranges in the disease-free population living in our area, sera of 151 healthy blood donors (without positive personal and familiar thyroid anamnesis) were used. 25 639 thyroid tests – on the Architect i2000 analyzer (Abbott) – from 14 918 out-patients and 1874 hospitalized patients seen in 2008 were analyzed retrospectively.

Results: In our disease-free population the reference range for TSH is 0.34–4.32 mU/l, for FT4 9.4–17.7 and FT3 3.4–6.3 pmol/l. Among hospitalized patients the reference ranges are wider (TSH: 0.27–5.9, FT4: 9.6–21.91, FT3: 1.5–8.3). By using these reference ranges instead of that of the manufacturers, the need for free hormone tests would have been less by 5082 measurements. (fT4: −1928. fT3: −3158). That would have reduced the expense by 20%, (>4400 € saving per year) without affecting the diagnostic accuracy of the method.

Conclusion: It is well known that the distribution of TSH in the normal population is influenced by the iodine intake. Our results show that is worth and cost–effective to use area- and laboratory-specific reference ranges for evaluation of in vitro thyroid tests.

Article tools

My recent searches

No recent searches.